The thread has not been reviewed by Editors yet. Readers are advised to use their best judgement before accessing this thread.
This thread will be reviewed shortly.
If you think this thread contain inappropriate content, please report to
webmaster.
To reset the Dahua IP camera password:
Method 1: Web Interface
1. Open a web browser and type the camera's IP address.
2. Log in with the current username and password (default: admin/admin).
3. Go to Configuration > System > Account.
4. Click "Modify" next to the admin account.
5. Enter a new password and confirm.
6. Click "Save" or "Apply."
Method 2: ConfigTool Software
1. Download and install Dahua ConfigTool.
2. Connect to the camera using the software.
3. Go to Device > Account.
4. Select the admin account.
5. Click "Modify" and enter a new password.
6. Click "Apply."
Method 3: Reset Button
1. Locate the reset button (usually on the camera's back or bottom).
2. Press and hold the button for 10-15 seconds.
3. Release when the camera's LEDs flash.
4. Default password: admin/admin.
Method 4: NVR/DVR Interface (if connected)
1. Access the NVR/DVR web interface.
2. Go to Configuration > Camera > Account.
3. Select the camera.
4. Click "Modify" and enter a new password.
5. Click "Apply."
Default Passwords:
- Username: admin
- Password: admin (or 123456, depending on the model)
Post-Reset Steps:
1. Log in with the new password.
2. Update firmware (if necessary).
3. Configure camera settings.
Model-Specific Instructions:
For specific Dahua IP camera models (e.g., IPC-HDW, IPC-B, etc.), refer to the user manual or manufacturer's website.
Troubleshooting:
- Ensure correct IP address and port forwarding.
- Check camera firmware version.
- Contact Dahua support for assistance.
